Aqua Mix SameDay Grout Sealer

1.) Read entire label before using.

2.) SHAKE WELL before using.

3.) For new installations, sealer can be applied as soon as 2 hours after grouting.

4.) Grout joints must be clean, dry, and free of existing sealers or coatings.

5.) Invert can and point nozzle toward the grout, keeping nozzle 10”-16” (25 cm to 41 cm) from the surface.

6.) Depress nozzle and spray along grout lines. Some sealer will get on the tile, which will evaporate without the need to wipe dry. NOTE: Be sure any sealer that does not penetrate surface is removed from surface within 5 mminutes of application using absorbent paper or cotton towels.

7.) If 2 or more coats are applied, allow a minimum of 30 minutes drying time between coats. Be careful not to directly rub fresh grout if sealer is applied same day as grout.

8.) After 2 hours conduct a test to determine if surface is completely sealed by applying water droplets to the surface. If water is absorbed, apply an additional coat. Wait 2 hours and repeat the test.

9.) Ready for surface traffic 2 hours after final coat. Keep area dry for 12 hours. Achieves full cure in 24 hours.

10) May be reapplied as needed to grout joints that are clean.

For Pre-Grouting Application:

Apply over clean stone or tile a minimum of 2 hours prior to grouting - follow application procedures above.

Limitations:

• Do not allow sealer to come in contact with any non-recommended surface.

• May slightly lighten or darken some surfaces.

• Sealer will not prevent surface wear or etching from acids or caustic chemicals.

It covers approximately 300 to 500 sq. ft. (28 m2 to 46 m2) per 15-oz. can (444 ml), depending on size and porosity of grout joint, temperature, humidity, and method of application.