Axson Liquid Transparent Flowing
Wood & Stone Company Axson Liquid Transparent Flowing is ideal for general repair and bonding of horizontal pieces. It may be used to fill large cracks or holes and to provide protective coatings. Imitation stone can easily be made by adding it to stone powder while adding quartz sand in ratio of 1:3 to 1:4 produces artificial resin mortar.
All surfaces must be dry and free of grease, oil, efflorescence and dust. Transparent Polyester products will bond to moist surfaces; however, a dry surface will provide the best results. Because our products do not bond with polyethylene plastics, containers of this material are ideal for mixing purposes.
If needed, add Polyester Coloring Pastes to the mastic before mixing the mastic with the hardening paste. The Correct amount of hardener is 2% to 4% of mastic by weight; this is approximately a 1/2" to 1" bead of hardener for every tablespoon of mastic. Additional hardener speeds the curing time, but causes a deeper yellowing and reduces the bond strength. Too little hardener will result in a mixture that will not cure. Ambient temperature also affects the curing time. Warmer temperatures speed the curing process, while temperatures below 32° F/0° C will require heating the mixture to start the curing process. The product should be mixed thoroughly and will remain workable until gelling occurs, at which point the product becomes rubbery and excess material may be removed with a razor or chisel. The product should not be worked once gelling has begun.
• When bonding stones together, clamps and jigs should be used to ensure a thin bond layer (less than 0.016 inches/0.4 mm) is achieved, thereby providing the strongest bond. After curing, the stone piece may be further processed without damaging the material.