Home > Setting Materials > Grout, Epoxy & Additives >

Custom CEG-Lite, Part A
Custom CEG-Lite Commerical Epoxy Grout, Part A


 
Alternative Views:


Price: $19.50

Product Code: 40-00252


Color:


Qty:  
Description
 

Custom CEG-Lite Commercial Epoxy Grout, Part A

COLOR CHART

Click Here: Purchase CEG-Lite, Part B

CEG-Lite Commercial Epoxy Grout, a lightweight 2-part 100% solids epoxy grout formulated with Custom’s exclusive Custom Lite Technology. CEG-Lite represents a major breakthrough in epoxy technology, delivering the high stain and chemical resistance professionals expect, combined with handling characteristics and versatility that far surpasses other epoxy grouts.

CEG-Lite Epoxy Grout is formulated with the same recycled content found in Custom’s other lightweight setting materials, making it the first 100 percent solids epoxy grout that contributes to LEED certification based on recycled content, which also affects the handling of the product, giving a smoother consistency providing increased spread ability.

NOTE: The following colors were discontinued in March 2015 and will only be available while supplies last: Antique Linen, Quarry Red Clay, Chaparral, Canvas, Camel, White Dove, Arctic Ice, Moss, Butter Cream, Ocean Blue, Burnt Clay, Bay Leaf, Onyx Green, Slate Gray, Admiral Blue, Bonsai, and Rose Beige.


Features:
  • Use with virtually any tile
  • Use to fill joint widths from 1/16 in. to 1/2 in.
  • Color consistent, stain and chemical resistant
  • Initial set in 4 hours, final set in 5 hours



Mixing Procedures:

Open Part B and stir thoroughly to eliminate the effects of settling due to shipping. Add the entire contents of the pigment Part A to Part B and stir to produce a homogeneous consistency, eliminating any color streaks from appearing in the mixed unit. Do not mix partial units. Make sure to scrape bottom and sides of container during mixing.


NOTE: If using small 1-gallon unit, mix with 1 unit of color. If using large 2-gallon unit, mix with 2 units of color. If a power mixer is used, it must be 300 RPM or less to avoid entrapping air bubbles which can cause pinholes in the grout. Do not overmix as this will cause the epoxy to flash set


Coverage will vary by joint size. See Data Sheet for more information on coverage.

Material Calculator

MSDS

Data Sheet


You may also like...
Custom CEG-Lite, Part B
Price: $51.38

Add
Custom CEG-Lite, Part B

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Setting Materials > Grout, Epoxy & Additives
Setting Materials
Custom Building Products
Custom Building Products > Grout