Custom Polyblend Non-Sanded Tile Grout
Custom Polyblend Non-Sanded Tile Grout is a polymer-modified grout that produces hard, dense joints that are resistant to shrinking, cracking and wear. This polyblend grout is formulated with proprietary technology to ensure durability, color consistency and quick setting. Use non-sanded grout for joints up to 1/8” (3 mm). Protected by MoldGard® Technology to resist mold and mildew growth.
- For grouting soft glazed tile, marble or other polished stone that could be scratched by sanded grouts.
- For grout joints up to 1/8" (3 mm).
- Use on floors, countertops, walls, ceilings, showers, fountains and pools.
- For interior or exterior installations.
- Rated (ASTM C627) for residential to extra heavy commercial use.
Installation to conform to ANSI A108.10. Lightly dampen absorptive, highly porous tile with clean, cool water but leave no standing water in the joints. Holding a rubber grout float at a 45° angle, force grout diagonally into joints ensuring joints are completely filled. Remove excess grout using edge of float held at a 90° angle. Cleanup can begin when grout can be only slightly indented when pushed hard with your fingernail or about 10 - 20 minutes depending on type of tile and ambient temperature.
Use as little water as possible for grout cleanup. Excess water will weaken the joint, cause variation in color and may cause shrinkage, cracks or pinholes. Smooth and level joints and remove excess grout from tile with a damp (not wet) small pore grout sponge using a circular motion. Change water and rinse sponge frequently. Using clean water and sponge will enhance color uniformity. Wait 2 hours before removing haze from tile surface with a soft, dry cloth.
Coverage will vary depending on tile size and joint width.
Color Chart: Click Here