Miracle Sealants Epoxy Grout Film Remover
Miracle Sealants Epoxy Grout Film Remover is a non-acid cleaner designed for the removal of epoxy grout film from tile, concrete and stone surfaces. Its formula is recommended for use on ceramic tile, porcelain tile, natural stone and concrete.
- Ceramic Tile
- Porcelain Tile
- Natural Stone
- Fast Acting
- Easy to Use
- Low Odor
Small Areas or Spots: Apply Epoxy Grout Film Remover to the surface with a paint brush. Try to avoid getting on the grout joint. Allow to remain on the surface for 20 - 30 minutes and check repeatedly for softening of the cured epoxy film. Allow to remain on the surface until the epoxy film is easily loosened.
Remove product and residual epoxy film using a stiff-bristled brush (not steel wire) or coarse nylon scrubbing pad. Multiple applications may be necessary for more difficult situations. After removing residue, scrub the surface with a nylon pad and a solution of Mira Clean #1. Remove cleaning solution with a wet vacuum. Rinse with clean water where necessary and allow to dry.
Large Areas - Floors: Pour directly onto the surface and spread liberally with a brush or lamb’s wool applicator. Work small areas approximately 3 feet wide. Avoid stepping into the solution. Allow to sit on the surface 15- 30 minutes and agitate with a stiff brush. Begin checking for softening of the epoxy film every 5 minutes.
Once the epoxy film has softened, remove it and the Epoxy Grout Film Remover with a squeegee, clean towels or mops. Multiple applications may be necessary. After removing residue, scrub the entire surface with a nylon brush or pad and a solution of H2O Strip. Remove the cleaning solution with a wet vacuum. Rinse with clean water where necessary and allow to dry.
It covers approximately 50 - 150 square feet per gallon (4 - 14 square meters per 3.785 liters).