All previous applied sealers, coatings, and/or waxes must be removed using Mira Strip or H2O Strip as directed. Mix Poultice Powder Plus with “distilled water” or an appropriate chemical to form a peanut butter-like paste. The paste should be pliable but not runny.Apply the paste directly to the stain approximately 1/4" - 1/2" thick. Overlap the stain by approximately 1/4"- 1/2". Cover the paste with plastic wrap and tape the plastic with “non-marking” tape to create an airtight seal. Allow the paste to dry completely, approximately 24 - 48 hours.Remove the plastic wrap and scrap the dried paste from the substrate with a non-scratching utensil like a wooden spoon or plastic putty knife, or spatula. Rinse off all residue with clean “distilled water.” If the stain is lighter but not completely removed, repeat the same procedures.It may be necessary to use multiple applications to remove some stains. Some stains can be removed more easily by mixing the appropriate chemical with the product. Refer to the Miracle Sealants Company Stain Removal Guide for additional information.
Back to top