Submit search
The Omega Diamond Red Ripper Ultralight Stone Router is our lightest router yet! Weighing in at only 11 lbs, you can easily pick up this router with one hand! It is built for profiling sinks and edges, and is perfect for pre-fabs. The built-in hydroplaning base helps the router move smoothly over the surface of the stone without scratching. Works on both natural and engineered stone. While the router is light, it is no lightweight when it comes to the size of bits it can use - almost all standard 7/8 bore with M10-1.5 bolt router bits will fit and be usable, including all common 2, 3, and 4cm bits. We've even seen guys swing larger bits, but that can cause the machine to become unbalanced, requiring a weight in the back to level things back out again! Water Feed Option Water Feed option is sold separately. Keeping bits properly wet while routing the inside of a sink - or anywhere else you have inside corners - can be a bear: the hose is always running into the stone or missing the grinding or polishing surface. The extra heat causes bits, in particular polishing bits, to heat up and prematurely wear - something no one wants to happen. With the water feed option, the water is sent directly through the center of the spindle and into the center of the bit where coolant-through bits can then sling the water right onto the working surface no matter where that surface is. This keeps the bit and stone fully wet at all times, allowing for maximum bit life and a perfect polish. Manufacturer Part # 015-764 Features
Back to top