Schluter Waterproofing Membranes - Kerdi & Ditra

Schluter-DITRA-DRAIN is a drainage membrane designed for use within thin-bed ceramic and stone tile assemblies in exterior applications. DITRA-DRAIN is typically installed over the Schluter-KERDI bonded waterproofing membrane.

Schluter-DITRA is a polyethylene membrane with a grid structure of square cavities, each cut back in a dovetail configuration, and an anchoring fleece laminated to its underside.

Schluter®-KERDI is a pliable, sheet-applied, bonded waterproof membrane and vapor retarder with limited crack-bridging capabilities. Now with printed grid lines.

Schluter's Kerdi-Board is a lightweight and easy-to-use multifunctional tile substrate and building panel that can be used to create a broad range of building elements, such as showers, bathtub surrounds, and other bonded waterproofing assemblies with tile coverings.

Use KERDI-BAND, in widths of 5" (12.5 cm), 7-1/4" (18.5 cm), or 10" (25 cm) to seal butt joints or corner joints.

Schluter-DITRA-XL serves as an uncoupling layer, waterproofing membrane, and vapor management layer that accommodates moisture from beneath the tile covering.

KERDI-FLEX, in 5" (12.5 cm) or 10" (25 cm) widths, is used to seal expansion joints or flexible edge joints.

Schluter-KERDI-KERECK are preformed, seamless corners made of Schluter-KERDI for waterproofing inside and outside corners.

Schluter Square Notch Trowel 1/8" x 1/8" for Kerdi installation.

The DITRA-TROWEL is specifically designed to install Schluter-DITRA.

Schluter Kerdi-Seal Mixing Valve 4-1/2" Opening

Schluter-Ditra-Roller is used to embed Ditra/Ditra-XL in the bond coat
during membrane installation.

Schluter SET® is a premium, unmodified thin-set mortar for use as a bond coat within tile assemblies that is optimized for use with Schluter® membranes and boards.

Schluter ALL-SET® is a specialized, modified thin-set mortar for use as a bond coat within tile assemblies that is optimized for use with Schluter® membranes and boards.